Note: Those shipping costs are only estimates; the actual shipping
cost will be shown on the order page.
Shipping to
{{cname}}
Product Description
Customer Reviews(1 Reviews)
4.8
Amazing value for money !
I was skeptical at first, but results went beyond expectations.
We use them (we ordered a total of 12 , mixed 50 and 100 W) to replace an outdated and Kilowatt hungry light system of a historical church.
Power is there, light is a pleasant white, with an homogoneous diffusion..
Installationwise, you must design your own brackets to orient the light. The device weights only 150 gram and thus can be hold in place by a simple ntlon cord tied around a pillar, without boring a hole !
Negative;
- The 'groubd (yellow) cable is affixed to the reflector by a small river. In half of our devices, the river had not been properly tightened. Easy to correct, but not good for safety .
- the wires are 1) very short 2) so thin that they are difficult to connect using régular equipment. It is best to silder 1 inch of thicker wire to each of the wire than spend 20 mns trying to convince the thin wire to go in the right tiny hile under the right screw !
- I would not use these devices outdoor as shown on the pictures. I am sure the LEDS and electronics are "IP65" as indicated, but in my wet country (West coast of France), the aluminium would be eaten up in a few month.
The device does heat very reasonably (reflector recahes 40° Celsius after 10 mns.
They have
Amazing value for money ! I was skeptical at first, but results went beyond expectations. We use them (we ordered a total of 12 , mixed 50 and 100 W) to replace an outdated and Kilowatt hungry light system of a historical church. Power is there, light is a pleasant white, with an homogoneous diffusion.. Installationwise, you must design your own brackets to orient the light. The device weights only 150 gram and thus can be hold in place by a simple ntlon cord tied around a pillar, without boring a hole ! Negative; - The 'groubd (yellow) cable is affixed to the reflector by a small river. In half of our devices, the river had not been properly tightened. Easy to correct, but not good for safety . - the wires are 1) very short 2) so thin that they are difficult to connect using régular equipment. It is best to silder 1 inch of thicker wire to each of the wire than spend 20 mns trying to convince the thin wire to go in the right tiny hile under the right screw ! - I would not use these devices outdoor as shown on the pictures. I am sure the LEDS and electronics are "IP65" as indicated, but in my wet country (West coast of France), the aluminium would be eaten up in a few month. The device does heat very reasonably (reflector recahes 40° Celsius after 10 mns. They have