Touch-Sensor Auto Bed Leveling Sensor Automatic Hot Bed Leveling Sensor 3D Printer Accessories Compatible with Creality Ender 3/Ender 3 Pro/CR-10/CR-10S Artillery Sidewinder X1

Straight forward easy mounting, just watch tutorial on how to update your firmware and then dial in your settings and your good to go! Precise first layer height is key for a good print and this tool allows me to achieve that

I have a ender 5 pro with updated 4.2.7 silent 32 bit board. It was very easy to install this BLTouch as it has a 5 pin connector that fits right on to the board. I preferred to watch a youtube video on how to set the Z off, lots of videos to pick from. Makes printing easier.

Good upgrade, as I hate leveling the bed super accurately. I used the appropriate firmware from the Creality site with no problems.

It does exactley as it says, was not hard to install and really works. Just keep in mind that the bed has to be leveled manually before using. As I found out setting the Z offset is a little challenging to set but with patience and carefulness it is not that hard to do or cause other problems.My prints are turning out better.

Works well for me. Install was easy, but my printer is already heavily modded and the issues I experienced were related to the mods I have installed. If this was a stock printer I wouldn't have had any issues and could have just used Creality OTS firmware. But it fixed my main complaint with my printer so I'm happy. Don't attempt this upgrade unless you have a pretty good understanding of how your printer works and are willing to troubleshoot.