Note: Those shipping costs are only estimates; the actual shipping
cost will be shown on the order page.
Shipping to
{{cname}}
Product Description
Customer Reviews(9 Reviews)
4
This is by far my favorite receiver to use with my Taranis transmitter. I always de-pin mine and direct solder the wires to make it smaller and lighter. Not much else to say about it, it just works and works well. My only complaint is the newer versions that are being shipped are using a different connector for the antenna cables and I bought a bunch of antenna replacement cables a while back because if you are flying a lot, you will damage the cables over time. I can't use any of those cables I bought on the newer X4R-SB units I've received this week. I can't find replacement cables anywhere for them either. For this reason, I am only giving this 4 stars. If they had kept the antenna connectors the same or documented what the new connector is called or where to get replacement cables, I'd have gladly given this a 5 star review.
John U.2018-01-16
This caused me to crash and break my new Runcam eagle fpv camera on my 185 racer. Range was maybe 30 or so yards and it dropped like a rock onto the concrete at full throttle ;( I am not a happy customer. Hope my motors and everything else is ok... Upon checking everything closely, I found the antenna to be loose which was the culprit. The receiver is working great and I was also able to also fix my fpv camera. Life is good!
DagDerNiT2018-01-11
Great receiver. It was authentic.
Nandi2018-01-08
Had to buy these twice. First one was DOA. But once you get it working, absolutely fantastic!
Tony2017-12-22
Overrated. Too much trouble to get it to work with a lost drone buzzer. Update: I purchased a new unit to use with my Omnibus F3 flight controller. Now that I understand how to use Betaflight to set it up the unit, most of my problems with the radio receiver are now resolved. The major flaw with the receiver is with the antennas. They break very easily so be careful with them. In addition, putting a replacement antenna on is a real pain. I ended up destroying my receiver when I pressed too hard trying to snap the antenna back on.
This is by far my favorite receiver to use with my Taranis transmitter. I always de-pin mine and direct solder the wires to make it smaller and lighter. Not much else to say about it, it just works and works well. My only complaint is the newer versions that are being shipped are using a different connector for the antenna cables and I bought a bunch of antenna replacement cables a while back because if you are flying a lot, you will damage the cables over time. I can't use any of those cables I bought on the newer X4R-SB units I've received this week. I can't find replacement cables anywhere for them either. For this reason, I am only giving this 4 stars. If they had kept the antenna connectors the same or documented what the new connector is called or where to get replacement cables, I'd have gladly given this a 5 star review.