Note: Those shipping costs are only estimates; the actual shipping
cost will be shown on the order page.
Shipping to
{{cname}}
Product Description
Customer Reviews(52 Reviews)
4.4
I installed it in the JAMMA cabinet and replaced the old CRT monitor with a liquid crystal panel. It works very well. Easy to configure and use I'm very happy.
James2019-06-20
I bought this to be able to use the old Amiga monitors and the newer LCD monitors, it does not have a manual, but YouTube Search can give you a lot of information about how it works. I found the pin information by searching the Amiga GBS 8200 website. I have an old Amiga monitor cable, I just need a 9-pin D-sub connector, some solder and a 5-volt, 2-amp power supply. After doing this work, I install everything on my LCD monitor. Have a very good image Keep in mind that this is just a table without a box. It also needs a 2-volt, 5-volt power supply to power the card.
Maryrose2019-06-20
It works well with my NeoGeo MVS board. Very easy to configure, the image looks very good.
Christine2019-06-19
With the C-128 Video DA and this small board, I was able to use the Commodore 128 with an LCD monitor in 80 column mode.
Damon2019-06-19
Excellent product. The favorite part is that it works for anything from 5 to 12 volts. You can take any old DC power and plug it in directly for this to work. I hope you use the HDMI interface.
I installed it in the JAMMA cabinet and replaced the old CRT monitor with a liquid crystal panel. It works very well. Easy to configure and use I'm very happy.